THROTTLE BODY REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01FUJM

      Remove the 4 clips and engine room side cover.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FTUX

      Remove the 7 clips and cool air intake duct seal.

  3. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01FTF3E01

      Place both hands on the sides of the cover as shown in the illustration, lift the cover to detach the 2 clips near the front in the order shown in the illustration, and then lift the cover further to detach the rear clip and remove the cover.

      Text in Illustration
      A01FVNL Areas to place hands when lifting cover

      Note

      If the cover is lifted rearward or forward and to the right or left at the same time, the cover may be damaged.

  4. REMOVE ENGINE UNDER COVER


    1. A01FVWF

      Remove the 13 screws, 3 clips and engine under cover.

  5. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator cap or reservoir tank cap while the engine and radiator are still hot. Pressurized hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug.

      A01FUNTE01
      Text in Illustration
      *1 Radiator Cap *2 Reservoir Tank Cap
      *3 Radiator Reservoir Tank *4 Radiator Drain Cock Plug
      *5 Cylinder Block Drain Cock Plug - -

    2. Remove the reservoir tank cap and drain the coolant.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the local regulations.

    3. Loosen the 2 cylinder block drain cock plugs and drain the coolant from the engine.

  6. DISCONNECT NO. 2 VENTILATION HOSE


    1. A01FRYF

      Disconnect the No. 2 ventilation hose from the cylinder head cover.

  7. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. A01FQ6J

      Disconnect the mass air flow meter connector.

    2. Disconnect the clamp from the air cleaner.

    3. A01FS2N

      Disconnect the VSV hose.

    4. A01FRIA

      Disconnect the 4 clamps.

    5. Remove the hose clamp and air cleaner cap with air cleaner hose.

  8. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. A01FRPC

      Disconnect the throttle motor connector.

    2. Remove the 4 bolts and disconnect the throttle body with motor assembly from the intake air surge tank.

    3. A01FSNU

      Disconnect the 2 water by-pass hoses from the throttle body with motor assembly.

    4. Remove the throttle body with motor assembly and gasket.