SFI SYSTEM, Diagnostic DTC:P060B

DTC Code DTC Name
P060B Internal Control Module A/D Processing Performance

DESCRIPTION

This DTC is stored when a communication error occurs in the ECM.

DTC No. DTC Detection Condition Trouble Area
P060B There is an ECM main CPU communication error (1 trip detection logic).

  • ECM

  • Knock sensor

MONITOR STRATEGY

Required sensors/Components ECM
Frequency of operation Once per driving cycle

CONFIRMATION DRIVING PATTERN


  1. Connect the GTS to the DLC3.

  2. Turn the power switch on (IG) and turn the GTS on.

  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC operation).

  4. Turn the GTS off.

  5. Turn the power switch off.

  6. Disconnect the GTS.

  7. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.

  8. Connect the cable to the negative (-) auxiliary battery terminal.

  9. Connect the GTS to the DLC3.

  10. Turn the power switch on (IG) and turn the GTS on.

  11. Wait 16 seconds or more.

  12. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  13. Read the pending DTCs.

    Tech Tips


    • If a pending DTC is output, the system is malfunctioning.

    • If a pending DTC is not output, perform the following procedure.

  14. Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.

  15. Input the DTC: P060B.

  16. Check the DTC judgment result.

    GTS Display Description
    NORMAL

    • DTC judgment completed

    • System normal
    ABNORMAL

    • DTC judgment completed

    • System abnormal
    INCOMPLETE

    • DTC judgment not completed

    • Perform driving pattern after confirming DTC enabling conditions
    N/A

    • Unable to perform DTC judgment

    • Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit

    Tech Tips


    • If the judgment result shows NORMAL, the system is normal.

    • If the judgment result shows ABNORMAL, the system has a malfunction.

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK FOR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Clear the DTCs Click here.

    5. Turn the GTS off.

    6. Turn the power switch off.

    7. Disconnect the GTS.

    8. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.

    9. Connect the cable to the negative (-) auxiliary battery terminal.

    10. Connect the GTS to the DLC3.

    11. Turn the power switch on (IG) and turn the GTS on.

    12. Wait 16 seconds or more.

    13. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    14. Check for DTCs.

      Result
      Result Proceed to
      DTC is not output A
      DTC P060B is output B
      DTC P060B and P0327, P0328, P0332 or P0333 are output C

    B

    REPLACE ECM Click here

    C

    GO TO DTC P0327, P0328, P0332 OR P0333 Click here

    A

    CHECK FOR INTERMITTENT PROBLEMS Click here