CRANKSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    2. Install the crankshaft position sensor to the timing chain cover assembly with a new bolt.

      Torque:
      6.5 N*m  { 66 kgf*cm, 58 in.*lbf }

      Note


      • If a crankshaft position sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or moved out of place during installation.

    3. Connect the crankshaft position sensor connector.

  2. INSTALL NO. 1 AIR CLEANER INLET


    1. Install the No. 1 air cleaner inlet with the bolt.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  3. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 7 clips.

  4. INSTALL ENGINE ROOM SIDE COVER


    1. Install the engine room side cover with the 4 clips.