THROTTLE BODY REMOVAL


  1. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the water filler cap sub-assembly or reservoir tank cap while the engine and radiator assembly are still hot. Pressurized hot engine coolant and steam may be released and cause serious burns.


    1. A01FSVR

      Remove the 3 screws and No. 4 center engine under cover.

    2. A01FTKGE01
      Text in Illustration
      *1 Engine Under Cover
      *a Vinyl Tube

      Install a vinyl tube to the radiator drain cock on the radiator side.

    3. Loosen the radiator drain cock sub-assembly.

      A01FTHJE01
      Text in Illustration
      *1 Radiator Drain Cock Sub-assembly *2 Reservoir Tank Cap
      *3 Water Filler Cap Sub-assembly *4 No. 2 Radiator Hose Sub-assembly

    4. Remove the reservoir tank cap and water filler cap sub-assembly. Then drain the engine coolant.

      Tech Tips

      Collect the engine coolant in a container and dispose of it according to the regulations in your area.

  2. REMOVE ENGINE ROOM SIDE COVER


    1. A01FTR0

      Remove the 4 clips and engine room side cover.

  3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01FS2FE01
      Text in Illustration
      *a When detaching the clip on the rear side of the cover
      A01FVNL Areas to be held when lifting the No. 1 engine cover sub-assembly

      Place both hands on either side of the No. 1 engine cover sub-assembly as shown in the illustration and detach the left and right side clips (1 and 2) near the front of the cover. Then, lift up the cover to detach the clip (3) on the rear side and remove the cover.

      Note


      • If the left and right sides and front and back sides of the cover are lifted up at the same time, the cover may be damaged.

      • If the procedures are not followed exactly, the clip on the rear side of the cover may be damaged.

      • If you attempt to remove the cover with only one of the front clips detached, the cover may be damaged.

  4. REMOVE AIR CLEANER CAP WITH NO. 2 AIR CLEANER HOSE


    1. A01FTMX

      Disconnect the mass air flow meter sub-assembly connector.

    2. Disconnect the wire harness clamp from the air cleaner cap with No. 2 air cleaner hose.

    3. Detach the 4 clamps.

    4. Loosen the hose clamp to remove the air cleaner cap with No. 2 air cleaner hose.

  5. REMOVE AIR CLEANER HOSE ASSEMBLY


    1. A01FSUR

      Slide the clamp and disconnect the ventilation hose from the cylinder head cover sub-assembly.

    2. Loosen the hose clamp to remove the air cleaner hose assembly from the throttle body with motor assembly.

  6. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. Disconnect the throttle body with motor assembly connector.

    2. A01FUK6E01
      Text in Illustration
      *1 No. 3 Water By-pass Hose
      *2 No. 2 Water By-pass Hose

      Slide the 2 clamps and disconnect the No. 3 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.

    3. Remove the 4 bolts and throttle body with motor assembly from the intake manifold.

    4. Remove the throttle body gasket from the intake manifold.