KICK-DOWN SWITCH INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL KICK DOWN SWITCH ASSEMBLY


    1. for LHD:

      Install the kick down switch assembly with the 2 bolts and nut.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. for RHD:

      Install the kick down switch assembly with the bolt and 2 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Connect the kick down switch connector.

  2. INSTALL NO. 3 DASH PANEL INSULATOR PAD

  3. INSTALL ACCELERATOR PEDAL

    Click here

  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect the connectors and attach the clamp.

    2. Attach the 2 claws to install the No. 1 instrument panel under cover sub-assembly.

    3. Install the 3 screws <A>.

  5. INSTALL INSTRUMENT SIDE PANEL LH


    1. Attach the 7 clips to install the instrument side panel LH.

  6. INSTALL FRONT DOOR OPENING TRIM COVER LH


    1. Attach the 5 claws to install the front door opening trim cover LH.

      Note

      After installing the front door opening trim cover LH, make sure that the lip of the front door opening trim weatherstrip LH is not pinched.

  7. INSTALL FRONT DOOR SCUFF PLATE LH


    1. Attach the 10 claws and 4 clips to install the front door scuff plate LH.