KICK-DOWN SWITCH REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE FRONT DOOR SCUFF PLATE LH


    1. Place your hands on the inner portion of the front door scuff plate LH and detach the 2 claws labeled A, 6 claws labeled B and 2 claws labeled C in the order shown in the illustration.

    2. Raise the front door scuff plate LH to detach the 4 clips on the outer side and remove it.

      A01FT08E01
      Text in Illustration
      *1 Claw A *2 Claw B
      *3 Claw C - -

  2. REMOVE FRONT DOOR OPENING TRIM COVER LH

    A01FVHD

    1. Detach the 5 claws and remove the front door opening trim cover LH.

  3. REMOVE INSTRUMENT SIDE PANEL LH

    A01FUFWE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel LH.

    2. Using a moulding remover, detach the 7 clips and remove the instrument side panel LH.

  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01FVMJ

    1. Remove the 3 screws <A>.

    2. Detach the 2 claws.

    3. Disconnect the connectors, detach the clamp and remove the No. 1 instrument panel under cover sub-assembly.

  5. REMOVE ACCELERATOR PEDAL

    Click here

  6. REMOVE NO. 3 DASH PANEL INSULATOR PAD

  7. REMOVE KICK DOWN SWITCH ASSEMBLY


    1. Disconnect the kick down switch connector.

    2. A01FQTQ

      for LHD:

      Remove the 2 bolts, nut and kick down switch assembly.

    3. A01FSSE

      for RHD:

      Remove the bolt, 2 nuts and kick down switch assembly.