SHIFT LEVER INSTALLATION


  1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY


    1. Temporarily install the transmission floor shift assembly to the body with the 4 bolts.

      Note

      Do not pinch the wire harness.

    2. A01FQYOE01
      Text in Illustration
      *A for LHD
      *B for RHD

      Tighten the 4 bolts in the order shown in the illustration.

      Torque:
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

    3. Connect the 3 connectors and 5 clamps to the transmission floor shift assembly.

  2. INSTALL NO. 1 CONSOLE BOX DUCT


    1. Install the No. 1 console box duct with the 2 clips.

  3. CONNECT CENTER AIRBAG SENSOR ASSEMBLY

    Click here

  4. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. A01FRT1E01

      Turn the transmission control shaft lever of the shift lever position sensor counterclockwise until it stops, and then turn it clockwise 2 notches to set it to N.

    2. A01FR5H

      Move the shift lever to N and tighten the nut while lightly pushing the lever toward R.

      Text in Illustration
      A01FTNO Push

      Note

      Do not push the shift lever too hard.

    3. After adjustment, check that the shift lever moves smoothly and the shift lever and gear operate correctly.

    4. Tighten the floor shift gear shifting rod sub-assembly with the nut.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

  5. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR


    1. Install the front No. 1 floor heat insulator with the 4 nuts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  6. INSTALL FRONT EXHAUST PIPE ASSEMBLY

    Click here

  7. INSPECT SHIFT LEVER POSITION


    1. When shifting from P to R with the power switch on (IG) and the brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.

    2. Start the engine and make sure that the vehicle moves forward when shifting from N to D and moves rearward when shifting to R. If the operation cannot be done as specified, inspect the shift lever position sensor and check the shift lever assembly installation condition.