TRANSMISSION WIRE REMOVAL


  1. REMOVE FRONT SUSPENSION MEMBER BRACE


    1. A01FSFT

      Remove the 4 bolts, and then turn the clip and remove the front suspension member brace.

      Tech Tips

      Do not remove the clip from the front suspension member brace.

  2. REMOVE NO. 2 ENGINE UNDER COVER


    1. A01FRKR

      Remove the 4 screws, 2 grommets and No. 2 engine under cover.

  3. DRAIN TRANSMISSION FLUID


    1. A01FVIH

      Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  4. REMOVE TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. A01FSMY

      Remove the 6 bolts, oil pan and gasket from the transmission.

    2. Remove the 4 transmission oil cleaner magnets from the oil pan sub-assembly.


      1. Collect any steel chips with the removed magnets. Carefully look at the foreign objects and particles in the pan and on the magnets to guess the type of wear which might be found in the transmission.

        Result
        Steel (magnetic)
        Bearing, gear and plate wear
        Brass (non-magnetic)
        Bushing wear

  5. REMOVE OIL STRAINER ASSEMBLY


    1. A01FT89

      Remove the 3 bolts and oil strainer from the valve body.

    2. A01FUA2E03
      Text in Illustration
      *1 O-Ring

      Remove the O-ring from the oil strainer.

  6. REMOVE TRANSMISSION WIRE


    1. A01FTJKE01
      Text in Illustration
      *1 Lock Plate
      *2 Wire Harness Clamp

      Remove the bolt, lock plate and ATF temperature sensor.

    2. Remove the bolt and wire harness clamp.

    3. Disconnect the 2 oil pressure switch connectors.

      Note

      When disconnecting the oil pressure switch connectors, do not bend the terminals.

    4. Disconnect the 3 connectors from the solenoid valves.

    5. A01FS9O

      Disconnect the wire connector.

    6. A01FRB9

      Using a 10 mm union nut wrench, remove the bolt.

    7. Pull out the transmission wire.