OIL PUMP MOTOR CONTROLLER REMOVAL


  1. PRECAUTION

    Click here

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


    1. Remove the luggage compartment floor mat.

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH


    1. Remove the luggage compartment trim cover LH.

  4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE ENGINE ROOM SIDE COVER


    1. A01FUJM

      Remove the 4 clips and engine room side cover.

  6. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FTUX

      Remove the 7 clips and cool air intake duct seal.

  7. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01FTF3E01

      Place both hands on the sides of the cover as shown in the illustration, lift the cover to detach the 2 clips near the front in the order shown in the illustration, and then lift the cover further to detach the rear clip and remove the cover.

      Text in Illustration
      A01FVNL Areas to place hands when lifting cover

      Note

      If the cover is lifted rearward or forward and to the right or left at the same time, the cover may be damaged.

  8. REMOVE NO. 1 AIR CLEANER INLET


    1. A01FPYO

      Remove the bolt and No. 1 air cleaner inlet.

  9. DISCONNECT NO. 2 VENTILATION HOSE


    1. A01FRYF

      Disconnect the No. 2 ventilation hose from the cylinder head cover.

  10. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. A01FQ6J

      Disconnect the mass air flow meter connector.

    2. Disconnect the clamp from the air cleaner.

    3. A01FS2N

      Disconnect the VSV hose.

    4. A01FRIA

      Disconnect the 4 clamps.

    5. Remove the hose clamp and air cleaner cap with air cleaner hose.

  11. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  12. REMOVE AIR CLEANER CASE


    1. A01FT1S

      Remove the 2 bolts, 2 clamps and air cleaner case sub-assembly.

      Note

      When removing the air cleaner case sub-assembly, be careful not to lose the grommet on the underside of the air cleaner case.

  13. DISCONNECT WIRE HARNESS


    1. A01FSGVE01
      Text in Illustration
      *a Pull out the lock
      *b Release the lock
      *c Rotate the lever

      Release the lock of the connector.

    2. Release the lock lever of the connector as shown in the illustration. Disconnect the connector from the oil pump motor controller.

    3. Disconnect the 2 clamps.

    4. A01FTCL

      Disconnect the connector from the oil pump motor controller.

    5. A01FUKOE01
      Text in Illustration
      *a Pull out the lock
      *b Release the lock
      *c Rotate the lever

      Release the lock of the connector.

    6. Release the lock lever of the connector as shown in the illustration. Disconnect the connector from the oil pump motor controller.

  14. REMOVE OIL PUMP MOTOR CONTROLLER


    1. A01FQ9G

      Remove the 2 bolts, clamp and oil pump motor controller with bracket.

      Note

      Do not drop the oil pump motor controller.

    2. A01FU5B

      Remove the 3 bolts and 2 oil pump motor controller brackets.