MOTOR CABLE INSTALLATION


  1. INSTALL MOTOR CABLE

    Note

    When installing the motor cable, minimize bending of the transmission end of the cable.


    1. A01FVX8E01
      Text in Illustration
      *A for LHD:
      *B for RHD:

      Align the matchmarks and install the 4 clamps to the motor cable.

      Note

      Be sure to install the wire harness clamps in the locations of the matchmarks placed during removal.

    2. Install the 3 O-rings to the terminal cables.

      Note


      • Check that the O-rings are not damaged before installing.

      • Install the O-rings making sure that they do not come out of the groove.

      • Do not get oil on the O-rings.

      • Check that the O-rings are not twisted.

    3. Using a 5 mm hexagon wrench, tighten the 3 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note


      • When installing the motor cable, minimize bending of the transmission end of the cable.

      • Protect the terminal cables and the installation area from water and foreign objects.

      • Make sure that the O-rings do not get caught between any parts.

      • Make sure that the tightening torque is between of 6.4 to 9.6 N*m (66 to 97 kgf*cm, 57 to 84 in.*lbf).

      Tech Tips

      To avoid putting too much pressure on the motor cable and bending its end, hold the end of the motor cable in one hand and use the other hand to line the motor cable up and install it against the side of the engine.

    4. Using an insulated tool, install the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Make sure that the tightening torque is between of 6.4 to 9.6 N*m (66 to 97 kgf*cm, 57 to 84 in.*lbf).

    5. Install 3 new terminal caps to the hybrid vehicle transmission.

      Note


      • Make sure that the O-rings do not get caught between any parts.

      • Make sure that the terminals caps are installed securely.

    6. Using an insulated tool, install the connector cover with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Make sure that the tightening torque is between of 6.4 to 9.6 N*m (66 to 97 kgf*cm, 57 to 84 in.*lbf).

  2. INSTALL ENGINE WITH TRANSMISSION

    Click here.

  3. PERFORM RESET MEMORY


    1. If the hybrid vehicle transmission assembly is replaced, initialize the learning value of the transmission Click here.