CRUISE CONTROL MAIN SWITCH INSTALLATION

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. INSTALL CRUISE CONTROL MAIN SWITCH


    1. Install the cruise control main switch with the 2 screws.

    2. Connect the connector.

    3. Attach the clamp.

  2. INSTALL STEERING PAD


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A01FRPHE01

      Connect the 2 airbag connectors to the steering pad.

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to only connect the connectors to each corresponding color.

    4. Push in the 2 locks to install the 2 airbag connectors.

    5. Connect the horn connector to the steering pad.

    6. Push the horn button assembly to attach the 3 pins carefully.

      Note


      • Make sure that the pins are securely inserted into the steering holes.

      • Make sure to engage the 2 upper pins first.

      • Make sure that the horn button assembly is securely installed.

  3. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. Attach the claw to install the lower No. 2 steering wheel cover.

  4. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. Attach the claw to install the lower No. 3 steering wheel cover.

  5. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH


    1. Install the luggage compartment trim cover LH.

  7. INSTALL LUGGAGE COMPARTMENT FLOOR MAT


    1. Install the luggage compartment floor mat.

  8. CHECK SRS WARNING LIGHT

    Click here