DYNAMIC RADAR CRUISE CONTROL SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Entire the following menus:


      • Powertrain / Radar Cruise / Data List.

      • Chassis / ABS/VSC/TRC / Data List.

    5. Check the values by referring to the table below.

      Radar Cruise
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Cruise Control Main Switch Cruise control main switch signal / ON or OFF

      ON: Cruise control main switch on

      OFF: Cruise control main switch off

      		 -
      RES/ACC Switch +/RES switch signal / ON or OFF

      ON: +/RES switch on

      OFF: +/RES switch off

      		 -
      SET/COAST Switch -/SET switch signal / ON or OFF

      ON: -/SET switch on

      OFF: -/SET switch off

      		 -
      Constant Speed Mode Constant speed mode signal / ON or OFF

      ON: Dynamic radar cruise control system is constant speed mode

      OFF: Dynamic radar cruise control system is vehicle-to-vehicle mode

      		 -
      Distance Control Switch Distance control switch signal / ON or OFF

      ON: Distance control switch on

      OFF: Distance control switch off

      		 -
      Stop Light SW 1 (M CPU) Stop light switch (Main-CPU) signal / ON or OFF

      ON: Depress brake pedal

      OFF: Release brake pedal

      		 -
      Stop Light SW 2 (M CPU) Stop light switch (Main-CPU) signal / ON or OFF

      ON: Depress brake pedal

      OFF: Release brake pedal

      		 -
      Stop Light SW 1 (S CPU) Stop light switch (Sub-CPU) signal / ON or OFF

      ON: Depress brake pedal

      OFF: Release brake pedal

      		 -
      Wiper (Lo) Windshield wiper switch Lo signal / ON or OFF

      ON: Windshield wiper switch Lo

      OFF: Windshield wiper switch except Lo

      		 -
      Wiper (Hi) Windshield wiper Lo switch Hi signal / ON or OFF

      ON: Windshield wiper switch Hi

      OFF: Windshield wiper switch except Hi

      		 -
      Tail Light Taillight switch signal / ON or OFF

      ON: Headlight dimmer switch on

      OFF: Headlight dimmer switch off

      		 -
      Vhcl Spd Calc-Whl Spd Vehicle speed / Min.: -327 km/h (-203 mph), Max.: 327 km/h (203 mph) Actual vehicle speed stored -
      Vhcl Spd-Brake ECU Vehicle speed / Min.: -327 km/h (-203 mph), Max.: 327 km/h (203 mph) Actual vehicle speed stored -
      Invalid Whl Spd Sens Num Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) Actual vehicle speed stored -
      Cruise Control Cruise control system operation signal / ON or OFF

      ON: Cruise control system operating

      OFF: Cruise control system not operating

      		 -
      Cruise Control Mode Cruise control mode signal / All Spd, Hi Spd or Normal

      All Spd: Vehicle-to-vehicle distance control mode (w/ Full speed Following Function)

      Hi Spd: Vehicle-to-vehicle distance control mode (w/o Full speed Following Function)

      Normal: Constant speed mode

      		 -
      Country# (F Radar Sens) Millimeter wave radar sensor country signal / JPN, NA, EURO, AUS, SAFC, OTHER, TWN, CHINA, THAI, GCC or NOFIX Actual country code -
      Country# (DSS) Driving support ECU country signal / JPN, NA, EURO, AUS, SAFC, OTHER, TWN, CHINA, THAI, GCC or NOFIX Actual country code -
      Front Radar Voltage Low voltage condition of Millimeter wave radar sensor

      ON: Millimeter wave radar sensor low voltage condition present

      OFF: Millimeter wave radar sensor normal

      		 -
      Frnt Radar Sens Temp Hi Millimeter wave radar sensor temperature high signal / ON or OFF

      ON: Millimeter wave radar sensor temperature high

      OFF: Millimeter wave radar sensor temperature normal

      		 -
      Front Whl Spd LH Sensor Front wheel speed sensor LH signal / Normal or Abnormal

      Normal: Wheel speed sensor normal

      Abnormal: Wheel speed sensor abnormal

      		 -
      Front Whl Spd RH Sensor Front wheel speed sensor RH signal / Normal or Abnormal

      Normal: Wheel speed sensor normal

      Abnormal: Wheel speed sensor abnormal

      		 -
      Rear Whl Spd LH Sensor Rear wheel speed sensor LH signal / Normal or Abnormal

      Normal: Wheel speed sensor normal

      Abnormal: Wheel speed sensor abnormal

      		 -
      Rear Whl Spd RH Sensor Rear wheel speed sensor RH signal / Normal or Abnormal

      Normal: Wheel speed sensor normal

      Abnormal: Wheel speed sensor abnormal

      		 -
      Yaw Rate Sensor Yaw rate value / Min.: -100 deg/s, Max.: 100 deg/s

      Min.; -100 deg/s

      Max.: 100 deg/s

      		 -
      Steering Angle Steering angle value / Min.: -3072 deg, Max.: 3070.5 deg

      Min.: -3072 deg

      Max.: 3070.5 deg

      		 -
      Zero Point Angle Sens Zero point value / Min.: -3072 deg, Max.: 3070.5 deg

      Min.: -3072 deg

      Max.: 3070.5 deg

      		 -
      Deceleration Sensor 1

      Deceleration sensor value / Min.: -14.7 m/s2, Max.: 14.7 m/s2

      Min.: -14.7 m/s2

      Max.: 14.7 m/s2

      		-
      Deceleration Sensor 2

      Deceleration sensor value / Min.: -14.7 m/s2, Max.: 14.7 m/s2

      Min.: -14.7 m/s2

      Max.: 14.7 m/s2

      		-
      Vehicle Acceleration

      Vehicle acceleration / Min.: -5 m/s2, Max.: 5 m/s2

      		Actual vehicle acceleration -
      Whl Spd/Deceleration Sen Wheel speed sensor / deceleration sensor signal / Avail or Not Avl

      Avail: Wheel speed sensor/ deceleration sensor valid

      Not Avl: Wheel speed sensor/ deceleration sensor not valid

      		 -
      CCS Throttle Opn Angle Cruise control throttle body open angle / Min.: 0%, Max.: 100% Actual throttle open angle -
      Closed Throttle Position Accelerator pedal idle position signal / ON or OFF

      ON: Accelerator pedal released

      OFF: Accelerator pedal depressed

      		 -
      ECM/PCM Command Origin of the driving force request / Pedal, None or DS

      Pedal: Accelerator pedal depressed

      None: Driving force not requested

      DS: Radar cruise control system operating

      		 -
      Max Val of Available DF Maximum value of available driving force / Min.: -65536 N, Max.: 65534 N Actual available driving force maximum value -
      Min Val of Available DF Minimum value of available driving force / Min.: -65536 N, Max.: 65534 N Actual available driving force minimum value -
      Tar Accel for ACC Target vehicle acceleration for vehicle-to-vehicle distance control mode / Min.: -5.12 m/s2, Max.: 5.08 m/s2 Actual target vehicle acceleration -
      Tar Accel for CCS Target vehicle acceleration for constant speed mode / Min.: -5.12 m/s2, Max.: 5.08 m/s2 Actual target vehicle acceleration -
      CCS Cancel by Low Spd Dynamic radar cruise control system (constant speed mode) low speed cancel signal / ON or OFF

      ON: Low speed cancel signal on

      OFF: Low speed cancel signal off

      		 -
      Cancel CCS by Com Delay Dynamic radar cruise control system (constant speed mode) cancel signal / ON or OFF

      ON: Cancel signal on

      OFF: Cancel signal off

      		 -
      Cancel CCS by RAM Malfnc Dynamic radar cruise control system (constant speed mode) cancel signal / ON or OFF

      ON: Cancel signal on

      OFF: Cancel signal off

      		 -
      A-CCS Cancl-Radar/Wip Dynamic radar cruise control system (vehicle-to vehicle distance control mode) cancel signal / ON or OFF

      ON: Cancel signal on

      OFF: Cancel signal off

      		 -
      A-CCS Cancl-ORC Malf Brake hold system malfunction condition

      ON: Malfunctioning

      OFF: Normal

      		 -
      A-CCS Cancl-ORC Brake system malfunction condition

      ON: Normal

      OFF: Malfunctioning

      		 -
      A-CCS Cancl-Logical Err Logic malfunction condition between brakes and driving support ECU

      ON: Malfunctioning

      OFF: Normal

      		 -
      FRS-Dirt Memorized dirt on millimeter wave radar sensor history / ON or OFF

      ON: Dirt on millimeter wave radar sensor history memorized

      OFF: Dirt on millimeter wave radar sensor history not memorized

      		 -
      Bad Wthr Hist (F Radar Sen) Memorized millimeter wave radar sensor bad weather history / ON or OFF

      ON: Millimeter wave radar sensor bad weather history memorized

      OFF: Millimeter wave radar sensor bad weather history not memorized

      		 -
      Forward Vhcl Relative Spd Vehicle ahead relative speed / Min.: -128 m/s, Max.: 127 m/s Actual vehicle ahead relative speed -
      Vehicle Approach Warning Forward vehicle approach warning signal / ON or OFF

      ON: Forward vehicle approaching

      OFF: Forward vehicle not approaching

      		 -
      Vhcl Stability Ctrl Buzz Skid control buzzer operation signal / ON or OFF

      ON: Skid control buzzer operating

      OFF: Skid control buzzer not operating

      		 -
      Reqest Driving Force Cruise control system request driving force / Min.: -65536 N, Max.: 65534 N Actual request driving force -
      Brk Rqst to Elec Ctrl Brk Braking request to brake control / Not Ctrl, None, Exist, None, Exist or Disable Driving support ECU control demand -
      Brk Rqst to Shift Down Braking request to hybrid control / None or Exist

      Exist: Braking control request

      None: Braking control not request

      		 -
      Operator Override Operator override / Able or Unable

      Able: Able to operate the override

      Unable: Unable to operate the override

      		 -
      Forward Vehicle Detect Vehicle ahead detection signal / Detect or No Dtct

      Detect: Vehicle ahead detected

      No Dtct: Vehicle ahead not detected

      		 -
      CCS Mem Vehicle Spd Cruise control memory vehicle speed / Min.: 0 km/h (0 mph), Max.: 320 km/h (199 mph) Actual vehicle speed stored in memory -
      Vehicle Distance Vehicle distance / Min.: 0 m, Max.: 255 m Actual vehicle distance -
      CCS Main SW-Ready Dynamic radar cruise control system standby condition / ON or OFF

      ON: Distance control switch ready is SET

      OFF: Distance control switch switch ready is UNSET

      		 -
      CCS System Check Multi-information display of combination meter "Cruise Control System Check" display signal / ON or OFF

      ON: When displayed

      OFF: When not displayed

      		 -
      Radar Millimeter wave radar sensor signal / Stop or Emission

      Stop: Millimeter wave radar sensor signal stopped

      Emission: Millimeter wave radar sensor signal sent

      		 -
      # Codes Number of present trouble codes / Min.: 0, Max.: 255 Number of DTCs will be displayed -
      Pre-Crash 2
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Country# (DSS) Destination country for driving support ECU / JPN, NA, EURO, AUS, SAFC, OTHER, TWN, CHINA, THAI, GCC, NOFIX Actual country code -
      ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Stop Light SW Stop light switch / ON or OFF

      ON: Brake pedal depressed

      OFF: Brake pedal released

      		 -
      Stop Light Relay Output No. 2 integration relay output / ON or OFF

      ON: Relay output on

      OFF: Relay output off

      		 -
      EBS Relay No. 2 integration relay (Emergency brake signal) / ON or OFF

      OFF: Always*1

      ON: Relay on*2

      OFF: Relay off*2

      		 -

      • *1: w/o Emergency Brake Signal

      • *2: w/ Emergency Brake Signal

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be display while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus:


      • Body Electrical / (desired system) / Active Test / All.

      • Chassis / ABS/VSC/TRC / Active Test.

    5. Perform the Active Test by referring to the table below.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Indicat. Lamp Cruise Cruise control indicator light ON / OFF -
      Indicat. Radar Cruise Radar cruise indicator light ON / OFF -
      Indicat. SET Cruise control SET indicator light ON / OFF -
      ABS/VSC/TRC
      Tester Display Test Part Control Range Diagnostic Note
      Buzzer Skid control buzzer ON / OFF Buzzer can be heard.
      Stop Light Relay No. 2 integration relay Relay ON / OFF Observe the stop light (the stop lights do not come on for 2 to 5 seconds).
      EBS Relay No. 2 integration relay (Emergency brake signal) Relay ON / OFF No change*

      • *: w/o Emergency Brake Signal