CRUISE CONTROL SYSTEM TC and CG Terminal Circuit

WIRING DIAGRAM

A01FVQCE13

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (DLC3 - POWER MANAGEMENT CONTROL ECU AND BODY GROUND)


    1. Disconnect the N92 power management control ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      N20-13 (TC) - N92-8 (TC) Always Below 1 Ω
      N20-4 (CG) - Body ground Always Below 1 Ω
      N20-13 (TC) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Click here