OIL LEVEL SENSOR REMOVAL


  1. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the drain plug and gasket.

    3. Install a new gasket and the drain plug.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

  2. REMOVE ENGINE UNDER COVER


    1. A01FVWF

      Remove the 13 screws, 3 clips and engine under cover.

  3. REMOVE FRONT SUSPENSION MEMBER BRACE


    1. A01FSFT

      Remove the 4 bolts, and then turn the clip and remove the front suspension member brace.

      Tech Tips

      Do not remove the clip from the front suspension member brace.

  4. REMOVE NO. 2 ENGINE UNDER COVER


    1. A01FRKR

      Remove the 4 screws, 2 grommets and No. 2 engine under cover.

  5. DISCONNECT INVERTER COOLING PIPE


    1. A01FTL7

      Remove the 3 bolts and disconnect the inverter cooling pipe.

  6. REMOVE ENGINE OIL LEVEL SENSOR


    1. A01FQ83

      Disconnect the engine oil level sensor connector.

    2. Remove the 4 bolts and engine oil level sensor.

    3. A01FSUHE01
      Text in Illustration
      *1 Cutting Position
      *2 Supply Part

      Cut off the gasket as shown in the illustration.

    4. Remove the gasket from the engine oil level sensor.

      Tech Tips

      After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.