CANISTER (w/ Canister Pump Module) REMOVAL


  1. REMOVE REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY


    1. A01FU7K

      Disconnect the 4 grommets and remove the 6 clips and rear No. 1 floor board.

      Text in Illustration
      A01FTNO Clip A
      A01FRJI Clip B
      A01FRV5 Grommet

  2. REMOVE CHARCOAL CANISTER ASSEMBLY


    1. A01FVIK

      Disconnect the wire harness from the 3 clamps.

    2. A01FVJZ

      Disconnect the 2 quick connectors, purge line hose and connector.

    3. A01FT2S

      Remove the 3 nuts and charcoal canister assembly.

  3. REMOVE CHARCOAL CANISTER BASE BRACKET


    1. A01FUVO

      Remove the 2 bolts and charcoal canister base bracket.

  4. REMOVE CANISTER PUMP MODULE


    1. Before removing the canister pump module, clean the canister by blowing air into it to ensure that the canister is free of foreign matter.

      Note


      • Make sure to clean the canister using only air.

      • Do not use gasoline, thinners or solvents.

    2. A01FUWPE01
      Text in Illustration
      *1 Protective Tape

      While disengaging the 2 claws as shown in the illustration, push the canister pump module upwards using a screwdriver to remove it.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Check if the canister contains foreign matter such as mud or water.


      1. A01FRYZ

        Visually check that the inside of the canister is free of foreign matter.

      2. Hold the canister upside down to make sure that the canister is free of foreign matter.

        If the canister contains foreign matter, replace the canister.