PCV VALVE REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01FS2FE01
      Text in Illustration
      *a When detaching the clip on the rear side of the cover
      A01FVNL Areas to be held when lifting the No. 1 engine cover sub-assembly

      Place both hands on either side of the No. 1 engine cover sub-assembly as shown in the illustration and detach the left and right side clips (1 and 2) near the front of the cover. Then, lift up the cover to detach the clip (3) on the rear side and remove the cover.

      Note


      • If the left and right sides and front and back sides of the cover are lifted up at the same time, the cover may be damaged.

      • If the procedures are not followed exactly, the clip on the rear side of the cover may be damaged.

      • If you attempt to remove the cover with only one of the front clips detached, the cover may be damaged.

  2. REMOVE PCV VALVE SUB-ASSEMBLY


    1. A01FSYN

      Slide the clamp and disconnect the PCV hose from the PCV valve sub-assembly.

    2. A01FSCW

      Using a 19 mm deep socket wrench, remove the PCV valve sub-assembly from the cylinder head cover sub-assembly.