ABSORBER CONTROL ACTUATOR (for Rear Side) INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL ABSORBER CONTROL ACTUATOR


    1. A01FRBHE08
      Text in Illustration
      *a 40°

      Check that the control rod of the rear shock absorber is in the position shown in the illustration.

      Note

      If the control rod is not in the position shown in the illustration, turn the control rod to adjust the position before installing the absorber control actuator.

    2. Install the absorber control actuator to the actuator support bracket.

    3. A01FQBAE01
      Text in Illustration
      *a 40°

      Turn the actuator clockwise approximately 40° until a click is felt.

      Note


      • Before turning the actuator, make sure to check that the actuator output shaft and control rod are securely connected.

      • Do not turn the actuator more than 40°.

      • Do not drop the absorber control actuator. If it is dropped, replace it with a new one.

    4. Connect the connector.

  2. INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER LH

    Click here