МАСЛЯНЫЙ НАСОС ПОВТОРНАЯ СБОРКА


  1. INSTALL FRONT OIL PUMP OIL SEAL


    1. A01FHTZE01

      Using SST and a hammer, tap in a new front oil pump oil seal.

      SST
      09350-30020   ( 09351-32140 )
      Standard depth
      -0.2 to 0.2 mm (-0.00787 to 0.00787 in.)

      Tech Tips

      The front oil pump oil seal end should be flush with the outer edge of the front oil pump body sub-assembly.

    2. Coat the lip of the front oil pump oil seal with MP grease.

  2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY


    1. Place the oil pump body on the torque converter clutch.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. A01FEBJ

      Coat the front oil pump driven gear with ATF.

    2. Install the front oil pump driven gear to the front oil pump body sub-assembly.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR


    1. A01FFD8

      Coat the front oil pump drive gear with ATF.

    2. Install the front oil pump drive gear to the front oil pump body sub-assembly.

  5. INSTALL FRONT OIL PUMP BODY O-RING


    1. A01FGUJ

      Coat a new front oil pump body O-ring with ATF.

    2. Install the front oil pump body O-ring to the oil pump body.

  6. INSTALL STATOR SHAFT ASSEMBLY


    1. A01FIXN

      Align the stator shaft with each bolt hole and install it.

    2. Using a T30 ''TORX'' socket wrench, install the 2 bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

  7. INSTALL STATOR SHAFT CLUTCH DRUM THRUST WASHER


    1. A01FHN1

      Align the 2 claws and install the stator shaft clutch drum thrust washer.

  8. INSTALL STATOR SHAFT PISTON


    1. A01FFVH

      Coat 2 new O-rings with ATF and install them to the stator shaft piston.

    2. A01FJ3OE01
      Text in Illustration
      *1 Stator Shaft Spring Sub-assembly
      *2 Stator Shaft Piston

      Install the stator shaft piston and stator shaft spring sub-assembly.

    3. Using a T30 ''TORX'' socket wrench, install the 5 bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

  9. INSPECT OIL PUMP DRIVE GEAR ROTATION


    1. A01FFWO

      Place the oil pump assembly on the torque converter clutch.

    2. Make sure that the drive gear rotates smoothly.

  10. INSTALL CLUTCH DRUM OIL SEAL RING


    1. Coat 4 new clutch drum oil seal rings with ATF.

    2. A01FG1M

      Squeeze the ends of the 4 clutch drum oil seal rings so that the gap becomes 8 mm (0.32 in.) or less, and then install them to the stator shaft groove.

      Note

      Do not expand the ring ends excessively.

      Tech Tips

      After installing the clutch drum oil seal rings, check that they rotate smoothly.

  11. INSTALL OIL PUMP O-RING


    1. A01FF0O

      Install a new oil pump O-ring with ATF and install them to the oil pump assembly.