ДАТЧИК ПОЛОЖЕНИЯ ПАРКИНГА / НЕЙТРАЛИ УСТАНОВКА


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Tech Tips

    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.


    1. Clean the bolt and the bolt hole.

    2. Apply adhesive to 2 or 3 threads on the end of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    3. Temporarily install the park/neutral position switch assembly to the automatic transmission assembly with the bolt.

      Tech Tips

      Tighten the bolt to the specified torque when adjusting the park/neutral position switch assembly.

    4. Install the lock washer and the nut to the park/ neutral position switch assembly.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }

    5. Temporarily install the transmission control shaft lever RH to the park/neutral position switch assembly with the spring washer and nut.

      Tech Tips

      Tighten the nut to the specified torque when adjusting the park/neutral position switch assembly.

    6. A01FIQJE01

      Turn the transmission control shaft lever RH counterclockwise until it stops, then turn it clockwise 2 notches.

    7. Remove the nut, spring washer and transmission control shaft lever RH from the park/neutral position switch assembly.

    8. A01FE9LE28
      Text in Illustration
      *a Neutral Basic Line
      *b Groove

      Align the neutral basic line with the groove as shown in the illustration.

    9. Hold the park/neutral position switch assembly in that position and tighten the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

    10. Using a screwdriver, bend the tabs of the lock washer.

    11. Install the transmission control shaft lever RH and spring washer with the nut.

      Torque:
      16 N*m  { 160 kgf*cm, 12 ft.*lbf }

    12. Connect the park/neutral position switch assembly connector.

  2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. A01FFQ3

      Connect the floor shift gear shifting rod sub-assembly to the transmission control shaft lever RH with the pin.

    2. Install a new clip.

  3. INSPECT SHIFT LEVER POSITION

    Click here

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION

    Click here