ЗАДНИЙ САЛЬНИК УДЛИНИТЕЛЯ КАРТЕРА ТРАНСМИССИИ ЗАМЕНА


  1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

    Click here

  2. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Снимите пробку сливного отверстия и прокладку, и слейте трансмиссионную жидкость.

    2. Установите новую прокладку и пробку сливного отверстия.

      Torque:
      20 Н*м  { 204 кгс*см, 15 фунт-сила-футов }
  3. REMOVE AUTOMATIC TRANSMISSION FLANGE YOKE ASSEMBLY


    1. A01FFCSE01

      Using SST and a hammer, loosen the staked part of the nut.

      SST
      09930-00010

      Note


      • Be sure to use SST with the tapered surface facing the shaft.

      • Do not grind the tip of SST with a grinder or other device.

      • Completely loosen the staked part of the lock nut when removing it.

      • Do not damage the threads of the shaft.

      Tech Tips

      Move the shift lever to P.

    2. A01FFXBE02

      Attach SST.

      SST
      09330-00021
      09950-30012   ( 09955-03040 )
    3. A01FFOVE01
      Text in Illustration
      *a Hold
      *b Turn

      Using SST and a 30 mm socket wrench, remove the lock nut.

    4. Remove SST.

    5. Tap the output automatic transmission flange yoke assembly with a plastic-faced hammer to remove it.

    6. A01FGRXE03
      Text in Illustration
      *1 Oil Seal

      Using a screwdriver, remove the oil seal from the automatic transmission flange yoke assembly.

  4. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


    1. A01FDBME03

      Using SST, remove the automatic transmission extension housing oil seal.

      SST
      09308-00010
  5. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


    1. Coat the lip of a new automatic transmission extension housing oil seal with MP grease.

    2. A01FIENE05

      Using SST and a hammer, drive in the automatic transmission extension housing oil seal l with the lip facing inside of the automatic transmission assembly.

      SST
      09316-60011   ( 09316-00011, 09316-00051 )
      Oil seal depth from flat end
      1.8 to 2.2 mm (0.0709 to 0.0866 in.)
  6. INSTALL AUTOMATIC TRANSMISSION FLANGE YOKE ASSEMBLY


    1. A01FI18E01

      Using SST and a hammer, drive in a new oil seal.

      SST
      09517-36010
      Oil seal drive in depth
      0 to 0.3 mm (0 to 0.0118 in.)
    2. Install the automatic transmission flange yoke assembly.

    3. A01FGEHE01
      Text in Illustration
      *a Hold
      *b Turn

      Attach SST.

      SST
      09330-00021
      09950-30012   ( 09955-03040 )
    4. Using SST and a 30 mm socket wrench, install and tighten a new lock nut.

      Torque:
      126 N*m  { 1280 kgf*cm, 93 ft.*lbf }
    5. Using a chisel and hammer, securely stake the lock nut.

  7. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

    Click here

  8. ADD AUTOMATIC TRANSMISSION FLUID

    Click here