ДАТЧИК ПОЛОЖЕНИЯ ПАРКИНГА / НЕЙТРАЛИ РЕГУЛИРОВКА


  1. DISCONNECT TRANSMISSION CONTROL SHAFT LEVER RH


    1. While pushing the shift lock release button, move the shift lever to N.

    2. A01FE0W

      Remove the nut and spring washer, and disconnect the transmission control shaft lever RH.

  2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Remove the bolt of the park/neutral position switch assembly.

    2. Clean the bolt and the bolt hole.

    3. Apply adhesive to 2 or 3 threads on the end of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
    4. A01FE9LE28
      Text in Illustration
      *a Neutral Basic Line
      *b Groove

      Align the neutral basic line with the groove as shown in the illustration.

    5. Hold the park/neutral position switch assembly in position and install the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

  3. CONNECT TRANSMISSION CONTROL SHAFT LEVER RH


    1. Connect the transmission control shaft lever RH with the spring washer and nut.

      Torque:
      16 N*m  { 160 kgf*cm, 12 ft.*lbf }

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Click here