OUTER REAR VIEW MIRROR GLASS INSPECTION


  1. INSPECT OUTER MIRROR LH


    1. A01FHLVE01
      Text in Illustration
      *a

      Component without harness connected

      (Outer Mirror LH)

      Check the mirror heater.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 3.5 to 4.9 Ω

        If the result is not as specified, replace the outer mirror LH.

    2. A01FDZTE01
      Text in Illustration
      *a

      Component without harness connected

      (Outer Mirror LH)
      *b EC Mirror Connector

      w/ Blind Spot Monitor:

      Note

      Do not apply battery voltage to the EC mirror connector.


      1. Check the blind spot monitor indicator operation.

        OK
        Tester Connection Specified Condition

        Battery positive (+) → Terminal 1

        Battery negative (-) → Terminal 2

        		 Blind spot monitor indicator comes on

        If the result is not as specified, replace the outer mirror LH.

    3. Check the EC mirror operation.


      1. Connect 1.5 V dry-cell battery.

      2. A01FF84E01
        Text in Illustration
        *a

        Component without harness connected

        (Outer Mirror LH)

        Apply battery voltage and check the EC mirror operation.

        Note

        Do not apply a voltage of 1.5 V or higher.

        OK
        Measurement Connection Specified Condition

        Positive (+) end of the battery → Terminal 1

        Negative (-) end of the battery → Terminal 2

        		 Mirror surface becomes dark

        If the result is not as specified, replace the outer mirror LH.

  2. INSPECT OUTER MIRROR RH


    1. A01FF8YE01
      Text in Illustration
      *a

      Component without harness connected

      (Outer Mirror RH)

      Check the mirror heater.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 3.5 to 4.9 Ω

        If the result is not as specified, replace the outer mirror RH.

    2. A01FHK0E01
      Text in Illustration
      *a

      Component without harness connected

      (Outer Mirror RH)
      *b EC mirror connector

      w/ Blind Spot Monitor:

      Note

      Do not apply battery voltage to the EC mirror connector.


      1. Check the blind spot monitor indicator operation.

        OK
        Tester Connection Specified Condition

        Battery positive (+) → Terminal 1

        Battery negative (-) → Terminal 2

        		 Blind spot monitor indicator comes on

    3. Check the EC mirror operation.


      1. Connect 1.5 V dry-cell battery.

      2. A01FFZAE01
        Text in Illustration
        *a

        Component without harness connected

        (Outer Mirror RH)

        Apply battery voltage and check the EC mirror operation.

        Note

        Do not apply a voltage of 1.5 V or higher.

        OK
        Measurement Connection Specified Condition

        Positive (+) end of the battery → Terminal 1

        Negative (-) end of the battery → Terminal 2

        		 Mirror surface becomes dark

        If the result is not as specified, replace the outer mirror RH.