DRIVER MONITOR CAMERA REMOVAL

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. DISABLE AUTO TILT AWAY FUNCTION


    1. Disable the autoaway/return function by changing the customize parameter Click here.

      CAUTION:

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off.

  2. REMOVE STEERING COLUMN COVER


    1. Remove the 3 screws.

    2. A01FDVR

      Detach the 2 claws to remove the steering column lower cover.

      Note

      Do not damage the tilt and telescopic switch.

    3. A01FDO1

      Detach the 4 clips.

    4. Detach the 2 claws.

    5. Disconnect the connectors and remove the steering column cover.

  3. REMOVE DRIVER MONITOR BRACKET


    1. A01FG4X

      Remove the screw.

    2. Detach the claw and remove the driver monitor bracket.

  4. REMOVE DRIVER MONITOR CAMERA


    1. A01FDA6

      Remove the 2 screws.

    2. A01FJ20

      Detach the 2 claws and remove the driver monitor camera.