CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION


  1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01FFBB

      Install the center airbag sensor assembly with the 2 bolts and nut.

      Torque:
      18 N*m  { 178 kgf*cm, 13 ft.*lbf }

      Note


      • If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the engine switch is first turned on (IG) after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

    4. Connect the connectors to the center airbag sensor assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Push in the connector lock lever to lock the airbag connector as shown in the illustration.

    6. Check that the waterproof sheet is properly set.

    7. Check that there is no looseness in the installation parts of the center airbag sensor assembly.

  2. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  5. INSPECT SRS WARNING LIGHT

    Click here