CENTER AIRBAG SENSOR ASSEMBLY REMOVAL


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  3. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  4. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01FI6A

      Push and pull the connector lock lever to release the connector lock as shown in the illustration.

    4. Disconnect the connectors from the center airbag sensor assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    5. Remove the 2 bolts, nut and center airbag sensor assembly.