CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Clean any remaining adhesive from the bolt holes for the curtain shield airbag assembly in the vehicle body.

    4. Temporarily install the curtain shield airbag assembly with the 4 hooks and 5 claws.

      Note

      Do not twist the curtain shield airbag assembly when installing it.

    5. Install 4 new bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

    6. Install 4 new clips and then push in 4 new pins to each clip.

    7. A01FEAN

      Connect the curtain shield airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    8. Push in the lock to install the airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  4. INSPECT SRS WARNING LIGHT

    Click here