CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

    CAUTION:

    When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01FE0XE01
      Text in Illustration
      *1 Protective Tape
      *2 Connector Lock

      Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. Remove the 4 clips.

      A01FHVB

      1. A01FFO3

        Using a clip remover, remove the pin.

        Tech Tips

        Perform the same procedure for the other pins.

      2. Using a screwdriver, detach the 2 claws and remove the clip from the body panel as shown in the illustration.

        Tech Tips

        Perform the same procedure for the other clips.

    5. Remove the 4 bolts.

      Note

      The bolts must not be reused.

    6. Detach the 4 hooks and 5 claws to remove the curtain shield airbag assembly.