FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for the driver side of RHD and LHD vehicles.

  • The procedures listed below are for the driver side of an LHD vehicle.


  1. INSTALL NO. 2 INSTRUMENT PANEL WIRE


    1. A01FE6T

      Connect the 2 airbag connectors to the instrument panel passenger airbag assembly.

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to only connect the connectors to each corresponding color.

    2. Push in the 2 locks to install the 2 airbag connectors.

    3. Attach the connector clamp to install the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.

  2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY


    1. Attach the 3 rear hooks of the instrument panel passenger airbag assembly to the rear of the airbag door.

    2. Push in the instrument panel passenger airbag assembly to attach the 3 front hooks to the front of the airbag door.

    3. Install the 2 screws to install the instrument panel passenger airbag assembly.

  3. INSTALL NO. 3 HEATER TO REGISTER DUCT


    1. Install the No. 3 heater to register duct with the 3 screws <F>.

  4. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT


    1. Attach the claw and 2 guides to install the No. 2 side defroster nozzle duct.

    2. Install the screw <F>.

  5. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. INSPECT SRS WARNING LIGHT

    Click here