KNEE AIRBAG ASSEMBLY (for Driver Side) INSTALLATION

Tech Tips


  • Use the same procedure for the driver side of RHD and LHD vehicles.

  • The procedures listed below are for the driver side of an LHD vehicle.


  1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01FHCD

      Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    4. Push in the lock to install the airbag connector.

    5. Attach the 3 claws to connect the hood lock control lever sub-assembly to the lower No. 1 instrument panel airbag assembly.

    6. Temporarily install the lower No. 1 instrument panel airbag assembly with the hook and pin.

    7. Install the lower No. 1 instrument panel airbag assembly with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  2. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY


    1. Connect the connectors.

    2. Attach the 9 clips and guide to install the No. 1 instrument panel safety pad sub-assembly.

  3. INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY


    1. Attach the 4 clips to install the No. 1 instrument panel garnish sub-assembly.

  4. INSTALL INSTRUMENT SIDE PANEL LH


    1. Attach the 7 clips to install the instrument side panel LH.

  5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect the connectors and attach the clamp.

    2. Attach the 2 claws to install the No. 1 instrument panel under cover sub-assembly.

    3. Install the 3 screws <A>.

  6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


    1. Attach the 5 clips and 2 guides to install the instrument panel finish panel end LH.

  7. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL


    1. Connect the connector.

    2. Attach the 9 clips and guide to install the center instrument cluster finish panel.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. INSPECT SRS WARNING LIGHT

    Click here