SPIRAL CABLE REMOVAL


  1. DISABLE AUTO TILT AWAY FUNCTION


    1. Disable the autoaway/return function by changing the customize parameter Click here

      CAUTION:

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off.

  2. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  3. REMOVE STEERING COLUMN COVER (w/o Driver Monitor Camera)


    1. Remove the 3 screws.

    2. A01FEB3

      Detach the 2 claws to remove the steering column lower cover.

      Note

      Do not damage the tilt and telescopic switch.

    3. A01FIW9

      Detach the 4 clips.

    4. Detach the 2 claws to remove the steering column upper cover.

  4. REMOVE STEERING COLUMN COVER (w/ Driver Monitor Camera)


    1. Remove the 3 screws.

    2. A01FDVR

      Detach the 2 claws to remove the steering column lower cover.

      Note

      Do not damage the tilt and telescopic switch.

    3. A01FDO1

      Detach the 4 clips.

    4. Detach the 2 claws.

    5. Disconnect the connectors and remove the steering column cover.

  5. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable with the battery connected and the engine switch on (IG).

    • Do not rotate the spiral cable with the battery connected and the engine switch on (IG).

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


    1. A01FEY2E01
      Text in Illustration
      *1 Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    2. Disconnect the other connector from the spiral cable with sensor sub-assembly.

    3. A01FF2J

      Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.

  6. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    Note


    • Remove the spiral cable sub-assembly from the steering sensor only when replacing it or the steering sensor.

    • Removing the steering sensor from the spiral cable sub-assembly without using a lock pin may result in a misaligned center position of the steering sensor. Therefore, make sure to use the lock pin provided with a new spiral cable sub-assembly or steering sensor when removing the steering sensor from the spiral cable sub-assembly.


    1. A01FIWN

      Install the lock pin to the steering sensor.

      Note


      • Use the lock pin provided with a new spiral cable sub-assembly.

      • Do not remove the lock pin before the spiral cable sub-assembly is installed to the steering sensor.

    2. A01FH8K

      Detach the 6 claws to remove the spiral cable sub-assembly from the steering sensor.