THEFT DETERRENT SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. According to the display on the GTS, read the Data List.

      Main Body (Main Body ECU [Multiplex Network Body ECU])
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ACC SW Engine switch / ON or OFF

      ON: Engine switch on (ACC)

      OFF: Engine switch off

      		 -
      IG SW Engine switch / ON or OFF

      ON: Engine switch on (IG)

      OFF: Engine switch off or on (ACC)

      		 -
      RR Door Courtesy SW Rear door courtesy light switch RH / ON or OFF

      ON: Rear door RH open

      OFF: Rear door RH closed

      		 -
      RL Door Courtesy SW Rear door courtesy light switch LH / ON or OFF

      ON: Rear door LH open

      OFF: Rear door LH closed

      		 -
      FR Door Lock Pos Front door RH unlock detection switch / LOCK or UNLOCK

      LOCK: Front door RH locked

      UNLOCK: Front door RH unlocked

      		 -
      FR Door Courtesy Front door courtesy light switch RH / ON or OFF

      ON: Front door RH closed

      OFF: Front door RH open

      		 -
      FL Door Lock Pos Front door LH unlock detection switch / LOCK or UNLOCK

      LOCK: Front door LH locked

      UNLOCK: Front door LH unlocked

      		 -
      FL Door Courtesy Front door courtesy light switch LH / ON or OFF

      ON: Front door LH closed

      OFF: Front door LH open

      		 -
      Hood Courtesy SW Engine hood courtesy switch / ON or OFF

      ON: Engine hood closed

      OFF: Engine hood open

      		 -
      RR-Door Lock Pos SW Rear door RH unlock detection switch / ON or OFF

      ON: Rear door RH or LH unlocked

      OFF: Rear door RH and LH locked

      		 -
      RL-Door Lock Pos SW Rear door LH unlock detection switch / ON or OFF

      ON: Rear door LH or RH unlocked

      OFF: Rear door LH and RH locked

      		 -
      Luggage Courtesy SW Luggage compartment door courtesy switch / ON or OFF

      ON: Luggage compartment door open

      OFF: Luggage compartment door closed

      		 -
      Intrusion Sens OFF SW*1 Intrusion sensor cancel switch / ON or OFF

      ON: Intrusion sensor cancel switch on

      OFF: Intrusion sensor cancel switch off

      		 -
      Intrusion Sensor*1 Status of the intrusion sensor detection / ON or OFF

      ON: Intrusion sensor detected

      OFF: Intrusion sensor not detected

      		 -
      Tilt Sensor*2 Status of the tilt sensor detection / ON or OFF

      ON: Tilt sensor detected

      OFF: Tilt sensor not detected

      		 -
      Intrusion Sen Conn*1 Intrusion sensor connecting / ON or OFF

      ON: Intrusion sensor connected

      OFF: Intrusion sensor not connected

      		 -
      Tilt Sensor Connect*2 Tilt sensor connecting / ON or OFF

      ON: Tilt sensor connected

      OFF: Tilt sensor not connected

      		 -

      • *1: w/ Intrusion Sensor

      • *2: w/ Tilt Sensor

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body or Entry&Start / Active Test.

    5. According to the display on the GTS, perform the Active Test.

      Main Body (Main Body ECU [Multiplex Network Body ECU])
      Tester Display Test Part Control Range Diagnostic Note
      Security Horn2*1 Theft warning siren OFF/ON -
      Vehicle Horn Vehicle horns OFF/ON -
      Security Horn*4 Security horn OFF/ON -
      Power for Intrusion sensor*2 Intrusion sensor power supply OFF/ON -
      Power for Tilt sensor*3 Tilt sensor power supply OFF/ON -

      • *1: w/ Theft Warning Siren

      • *2: w/ Intrusion Sensor

      • *3: w/ Tilt Sensor

      • *4: w/ Security Horn Assembly

      Entry & Start (Certification ECU [Smart Key ECU Assembly])
      Tester Display Test Part Control Range Diagnostic Note
      Immobiliser Indicator Security indicator light OFF/ON -