ENTRY AND START SYSTEM (for Start Function) PRECAUTION


  1. PRECAUTIONS WHEN USING GTS


    1. When using the GTS with the engine switch off to troubleshoot the entry and start system (for Start Function):

      Connect the GTS to the DLC3 and turn a door courtesy light on and off at 1.5 second or less intervals until communication between the GTS and vehicle begins (the GTS screen changes when communication begins).

  2. PRECAUTION FOR REGISTRATION


    1. If replacing any of the following parts, refer to the Service Bulletin.


      1. Certification ECU (smart key ECU assembly)

      2. Steering lock ECU (steering lock actuator assembly)

      3. ID code box (immobiliser code ECU)

      4. ECM

      5. Electrical key transmitter sub-assembly

      6. Main body ECU (multiplex network body ECU)

    2. If the certification ECU is replaced, the engine may not be able to start because the recorded lock position may not match the recorded lock position in the steering lock ECU (steering lock actuator assembly). After replacing the certification ECU, perform the following procedure.


      1. Move the shift lever to P.

      2. With the engine switch off, open and close the driver door, and then start the engine.