SLIDING ROOF HOUSING DISASSEMBLY


  1. REMOVE SLIDING ROOF HOUSING FRONT MOUNTING BRACKET LH


    1. A01FFU4

      Remove the bolt and sliding roof housing front mounting bracket LH.

  2. REMOVE SLIDING ROOF HOUSING FRONT MOUNTING BRACKET RH

    Tech Tips

    Use the same procedures described for the LH side.

  3. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A01FEBHE01
      Text in Illustration
      *1 Guide
      *2 Pin

      Detach the claw.

    2. Detach the guide and pin, and remove the map light bracket.

    3. A01FGKG

      Remove the 2 bolts and sliding roof drive gear sub-assembly.

  4. REMOVE SUNSHADE TRIM SUB-ASSEMBLY


    1. Remove the 2 screws.

      A01FDKYE01
      Text in Illustration
      *1 Guide - -
      *a Rearward - -

    2. Detach the guide and remove the sliding roof piece LH and RH.

    3. Slide and remove the sunshade trim sub-assembly.

  5. REMOVE REAR ROOF DRIP CHANNEL


    1. Using a screwdriver, detach the 2 claws and slide the rear roof drip channel rearward to remove it.

      A01FHG5E01
      Text in Illustration
      *1 Protective Tape - -
      *a Rearward - -

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

    Note

    Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


    1. A01FHB6

      Hold down the roof wind deflector panel sub-assembly.

    2. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

      A01FHO5E01
      Text in Illustration
      *1 Protective Tape - -
      *a Rearward - -

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the other sliding roof drive cable sub-assembly.

  7. REMOVE ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    1. Pull the spring as shown in the illustration to detach it at the 2 locations.

      A01FHPDE01
      Text in Illustration
      *1 Spring - -

    2. Pull the roof wind deflector panel sub-assembly as shown in the illustration to detach the 2 guides and remove the panel.

      A01FICXE01
      Text in Illustration
      *1 Guide - -