SLIDING ROOF HOUSING REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

    Click here

  5. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. REMOVE SLIDING ROOF SIDE GARNISH LH


    1. A01FHOA

      Detach the claws and remove the sliding roof side garnish LH.

  7. REMOVE SLIDING ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


    1. A01FFP1

      Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.

      Note

      To prevent the sliding roof glass and sliding roof drive gear from being displaced, fully close the sliding roof glass (sliding roof drive cable), and then remove the sliding roof glass sub-assembly.

  9. REMOVE SLIDING ROOF PANEL OR REMOVABLE ROOF WEATHERSTRIP


    1. Remove the sliding roof panel or removable roof weatherstrip from the sliding roof panel sub-assembly.

  10. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY


    1. A01FIOS

      for Clamp Type:


      1. Detach the claw and disconnect the sliding roof drain hose.

        Tech Tips

        Use the same procedure for the other 3 sliding roof drain hoses.

    2. A01FDRD

      for Clip Type:


      1. Expand the clip and disconnect the sliding roof drain hose.

        Tech Tips

        Use the same procedure for the other 3 sliding roof drain hoses.

    3. Remove the 8 bolts, 8 nuts or 12 nuts and sliding roof housing sub-assembly.

      A01FHZS