GENERATOR REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE ENGINE UNDER COVER


    1. A01FFKZE01
      Text in Illustration
      *A for 2WD
      *B for AWD

      for 2WD:

      Remove the 13 screws, 3 clips and engine under cover.

    2. for AWD:

      Remove the 10 screws, 3 clips and engine under cover.

  4. REMOVE FAN AND GENERATOR V BELT

    Click here

  5. REMOVE NO. 2 ENGINE COVER


    1. A01FH26

      Remove the 3 clips and clamp, then remove the No. 2 engine cover.

  6. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY


    1. A01FFAA

      Remove the bolt, No. 2 idler pulley cover plate and No. 2 idler pulley sub-assembly.

  7. DISCONNECT WIRE HARNESS


    1. A01FIK8E01

      Remove the 3 nuts (A) and disconnect the wire harness.

    2. Disconnect the 2 connectors (B).

  8. REMOVE GENERATOR ASSEMBLY


    1. Remove the terminal cap.

    2. A01FDTZE02

      Remove the nut and disconnect the generator wire.

    3. Disconnect the generator connector, and detach the 2 clamps.

    4. A01FHT9E01

      Disconnect the connector from the cooling fan ECU.

    5. A01FF4B

      Remove the nut, and disconnect the bracket.

    6. A01FDGW

      Remove the 2 bolts and generator.

    7. A01FG6M

      Remove the 2 bolts and 2 brackets.