BLIND SPOT MONITOR MAIN SWITCH REMOVAL


  1. REMOVE FRONT DOOR SCUFF PLATE LH


    1. Place your hands on the inner portion of the front door scuff plate LH and detach the 2 claws labeled A, 6 claws labeled B and 2 claws labeled C in the order shown in the illustration.

    2. Raise the front door scuff plate LH to detach the 4 clips on the outer side and remove it.

      A01FFCRE01
      Text in Illustration
      *1 Claw A *2 Claw B
      *3 Claw C - -

  2. REMOVE FRONT DOOR OPENING TRIM COVER LH

    A01FHVP

    1. Detach the 5 claws and remove the front door opening trim cover LH.

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    A01FD7VE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the center instrument cluster finish panel.

    2. Detach the 9 clips and guide.

    3. Disconnect the connector and remove the center instrument cluster finish panel.

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    A01FFFLE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument panel finish panel end LH.

    2. Detach the 5 clips and 2 guides and remove the instrument panel finish panel end LH.

  5. REMOVE INSTRUMENT SIDE PANEL LH

    A01FFR7E01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel LH.

    2. Using a moulding remover, detach the 7 clips and remove the instrument side panel LH.

  6. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    A01FGVBE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the No. 1 instrument panel garnish sub-assembly.

    2. Using a moulding remover, detach the 4 clips and remove the No. 1 instrument panel garnish sub-assembly.

  7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01FH83

    1. Remove the 3 screws <A>.

    2. Detach the 2 claws.

    3. Disconnect the connectors, detach the clamp and remove the No. 1 instrument panel under cover sub-assembly.

  8. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    A01FFNF

    1. Detach the 9 clips and guide.

    2. Disconnect the connectors and remove the No. 1 instrument panel safety pad sub-assembly.

  9. REMOVE BLIND SPOT MONITOR MAIN SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)


    1. A01FEB2

      Detach the 2 claws and remove the blind spot monitor main switch (integration control and panel assembly).