ULTRASONIC SENSOR (for Rear Side) REMOVAL


  1. REMOVE REAR BUMPER COVER

    Click here

  2. REMOVE NO. 3 LUGGAGE ROOM WIRE


    1. Disconnect the 4 ultrasonic sensor connectors.

      A01FEAO

    2. Detach the 4 clamps and remove the No. 3 luggage room wire.

  3. REMOVE NO. 1 ULTRASONIC SENSOR


    1. for Corner Sensor:


      1. A01FHXLE02
        Text in Illustration
        *A for RH Side
        *B for LH Side

        Detach the 2 claws and remove the No. 1 ultrasonic sensor.

    2. A01FFTX

      for Back Sensor:

      Detach the 2 claws and remove the No. 1 ultrasonic sensor.

      Tech Tips

      Use the same procedure for all No. 1 ultrasonic sensors.

  4. REMOVE ULTRASONIC SENSOR CLIP

    Tech Tips

    Use the same procedure for all ultrasonic sensor clips.


    1. A01FHDJE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the claw and remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor.

  5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    1. A01FESX

      Detach the 4 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper cover.

      Tech Tips


      • The illustration shows the No. 1 ultrasonic sensor retainer for the RH corner. The vertical orientation of the No. 1 ultrasonic sensor retainers for the LH corner and back sensor LH and RH is opposite that of the image shown in the illustration.

      • Use the same procedure for all ultrasonic sensor retainers.