BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1AB2

DTC Code DTC Name
C1AB2 Short to GND in Outer Mirror Indicator(Master)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects a ground short in the outer rear view mirror indicator RH.

DTC Code DTC Detection Condition Trouble Area
C1AB2

Both of the following conditions are met:


  • Blind spot monitor main switch (integration control and panel assembly) is on.

  • The current that is sent from the blind spot monitor sensor to the indicator is above a specified level for a specified period of time.

  • Harness or connector

  • Outer mirror RH

  • Outer rear view mirror assembly RH

  • Front multiplex network door ECU RH

  • Blind spot monitor sensor RH

WIRING DIAGRAM

A01FDOLE31

INSPECTION PROCEDURE

Note

When checking for DTCs, make sure that the blind spot monitor main switch (integration control and panel assembly) is on.

PROCEDURE


  1. CHECK DTC


    1. Clear the DTCs Click here.

    2. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      DTC C1AB2 is not output.

    NG

    CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - FRONT MULTIPLEX NETWORK DOOR ECU RH) Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  2. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - FRONT MULTIPLEX NETWORK DOOR ECU RH)


    1. Disconnect the T54 blind spot monitor sensor RH connector.

    2. Disconnect the Q4 front multiplex network door ECU RH connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      T54-4 (OMIR) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT OUTER MIRROR RH (OUTER REAR VIEW MIRROR INDICATOR RH)


    1. Remove the outer mirror RH Click here.

    2. Inspect the outer mirror RH (outer rear view mirror indicator RH) Click here.


    NG

    REPLACE OUTER MIRROR RH Click here

    OK

  4. CHECK OUTER REAR VIEW MIRROR ASSEMBLY RH


    1. Replace the outer rear view mirror assembly RH Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      DTC C1AB2 is not output.

    NG

    CHECK FRONT MULTIPLEX NETWORK DOOR ECU RH Click here

    OK

    END (OUTER REAR VIEW MIRROR ASSEMBLY RH IS DEFECTIVE)

  5. CHECK FRONT MULTIPLEX NETWORK DOOR ECU RH


    1. Replace the front multiplex network door ECU RH Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      DTC C1AB2 is not output.

    NG

    REPLACE BLIND SPOT MONITOR SENSOR RH Click here

    OK

    END (FRONT MULTIPLEX NETWORK DOOR ECU RH IS DEFECTIVE)