PARKING ASSIST MONITOR SYSTEM "Back Door is Open" is Displayed even after Back Door is Closed

DESCRIPTION

The multi-media module receiver assembly receives luggage compartment door open/close signals from the luggage closer motor assembly*1 or main body ECU [multiplex network body ECU]*2 via CAN communication. When the luggage compartment door is open, the camera aiming cannot be adjusted correctly because the rear television camera assembly is installed on the luggage compartment door. Therefore, when adjusting the camera aiming calibration while the back door is open, a luggage compartment door open warning message will be displayed on the screen and camera aiming adjustment will be canceled.


WIRING DIAGRAM

A01FIG9E01

INSPECTION PROCEDURE

Note


  • When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

PROCEDURE


  1. CHECK LUGGAGE COMPARTMENT DOOR OPENER SYSTEM


    1. Check the luggage compartment door opener system Click here.

      OK
      Luggage compartment door opener system is normally.
      Result
      Result Proceed to
      OK A
      NG (w/o Power Trunk Lid System) B
      NG (w/ Power Trunk Lid System) C

    B

    GO TO LUGGAGE COMPARTMENT DOOR OPENER SYSTEM Click here

    C

    GO TO LUGGAGE COMPARTMENT DOOR CLOSER SYSTEM Click here

    A

    USE SIMULATION METHOD TO CHECK Click here