PARKING ASSIST MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

VEHICLE BROUGHT TO WORKSHOP

NEXT

INSPECT BATTERY VOLTAGE

1. Measure the battery voltage with the engine switch off.

   Standard voltage
   11 to 14 V

   If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

   
   

   NEXT

CHECK NAVIGATION SYSTEM

1. Refer to the navigation system Click here.

   Result

   Result	Proceed to
   Navigation system is normal	A
   Navigation system is abnormal	B

   
   

   B

   GO TO NAVIGATION SYSTEM Click here

   A

CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

1. Use the GTS to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN (for LHD) DTC is output	B
   CAN (for RHD) DTC is output	C

   
   

   B

   GO TO CAN COMMUNICATION SYSTEM Click here

   C

   GO TO CAN COMMUNICATION SYSTEM Click here

   A

CHECK FOR DTC*

1. Check for DTCs and note any codes that are output Click here.

2. Clear the DTCs Click here.

3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   
   

   B

   Go to step 8

   A

PROBLEM SYMPTOMS TABLE

1. Refer to the Problem Symptoms Table Click here.

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

   
   

   B

   ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

   A

OVERALL ANALYSIS AND TROUBLESHOOTING

1. Data List / Active Test Click here

2. Terminals of ECU Click here

   
   

   NEXT

ADJUST, REPAIR OR REPLACE

NEXT

CONFIRMATION TEST

NEXT