PARKING ASSIST MONITOR SYSTEM TERMINALS OF ECU


  1. CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY

    A01FHFEE03

    1. Disconnect the N162 multi-media module receiver assembly connector.

    2. Measure the voltage and resistance to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      N162-12 (GND1) - Body ground W-B - Body ground Ground Always Below 1 Ω
      N162-15 (IG) - N162-12 (GND1) L - W-B Power source (IG) Engine switch on (IG) 11 to 14 V
      Engine switch off Below 1 V
      N162-16 (ACC1) - N162-12 (GND1) GR - W-B Power source (ACC) Engine switch on (ACC) 11 to 14 V
      Engine switch off Below 1 V
      N162-17 (+B1) - N162-12 (GND1) L - W-B Battery Always 11 to 14 V

    3. Reconnect the N162 multi-media module receiver assembly connector.

    4. Measure the voltage and check for pulses according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      N162-39 (CA+) - Body ground B - Body ground Power source Engine starts, shift lever in R 5.5 to 7.05 V
      N162-18 (V+) - N162-19 (V-) R - W Display signal Engine starts, shift lever in R, camera lens is not covered, displaying an image Pulse generation (See waveform 1)
      Engine starts, shift lever in R, camera lens is covered, blacking out the screen Pulse generation (See waveform 2)
      N162-40 (CGND) - Body ground Shielded - Body ground Shielding Always Below 1 V
      N162-1 (CANH) B CAN communication line - -
      N162-2 (CANL) W CAN communication line - -
    5. A01FDLVE01
      Text in Illustration
      *a Waveform 1
      *b Waveform 2
      *c Synchronization Signal
      *d Video Waveform

      Using an oscilloscope, check waveform.

      Tech Tips

      A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the multi-media module receiver assembly with the connector connected.

      Item Content
      Terminal No. (Symbol) N162-18 (V+) - N162-19 (V-)
      Tool Setting 200 mV/DIV., 50 μsec./ DIV.
      Condition

      Waveform 1: Engine starts, shift lever in R, camera lens is not covered, displaying an image

      Waveform 2: Engine starts, shift lever in R, camera lens is covered, blacking out the screen

      Tech Tips

      The video waveform changes according to the image sent by the rear television camera assembly.