LEXUS PARKING ASSIST-SENSOR SYSTEM OPERATION CHECK


  1. MALFUNCTION DISPLAY (MULTI-INFORMATION DISPLAY)


    1. Open circuit indication


      1. If there is an open circuit between the No. 1 ultrasonic sensor and the clearance warning ECU assembly or a sensor is malfunctioning, the malfunction is displayed as shown in the illustration.

        A01FITKE01

        Tech Tips

        If a sensor has an open circuit, check for DTCs and troubleshoot according to each inspection procedure Click here.

    2. Frozen indication


      1. If a sensor is covered with foreign matter, such as mud or snow, the affected sensor is displayed as shown in the illustration.

        A01FHDRE01

        Tech Tips

        If a frozen indication is displayed, proceed to "Sensor Frozen Indication (Dirty or Frozen)" Click here.

  2. MALFUNCTION DISPLAY (ACCESSORY METER ASSEMBLY [for 12.3 Inch], MULTI-DISPLAY [for 8 Inch])


    1. Open circuit indication


      1. If there is an open circuit between the No. 1 ultrasonic sensor and the clearance warning ECU assembly or a sensor is malfunctioning, the malfunction is displayed as shown in the illustration.

        A01FFC2E01

        Tech Tips

        If a sensor has an open circuit, check for DTCs and troubleshoot according to each inspection procedure Click here.

    2. Frozen indication


      1. If a sensor is covered with foreign matter, such as mud or snow, the affected sensor is displayed as shown in the illustration.

        A01FF0BE01

        Tech Tips

        If a frozen indication is displayed, proceed to "Sensor Frozen Indication (Dirty or Frozen)" Click here.

  3. DETECTION RANGE MEASUREMENT AND DISPLAY INSPECTION

    Note

    The following measurement and inspection will be performed with the shift lever in a position other than P. Be sure to apply the parking lever and depress the brake pedal firmly to prevent the vehicle from moving.


    1. Turn the engine switch on (IG).

    2. Turn the clearance sonar main switch on.

    3. Detection range measurement:


      1. Move the shift lever according to the table below.

        Measurement Area Shift Lever Position
        Front corner In any position other than P
        Front center In any position other than P or R
        Rear corner R
        Rear center

      2. Move a 60 mm (2.36 in.) diameter pole near each sensor to measure its detection range.

        Note

        These detection ranges are applicable when positioning the 60 mm (2.36 in.) diameter pole parallel or perpendicular to the ground. The detection range varies depending on the measuring method and type of obstacle (such as walls).

        Tech Tips

        Have an assistant move the pole.

        A01FINVE02

        Note

        The No. 1 ultrasonic sensor side view detection range (hatched area labeled *1) represents the cross section of the top view detection range A. The hatched area *1 does not represent the entire side view detection range.

        A01FFCHE02
        A01FEJKE04

    4. Front corner sensor display and buzzer operation check


      1. When the No. 1 ultrasonic sensors (front corner sensor) have detected an obstacle, check the displays and check that the buzzer sounds.

        Operation Condition
        Engine Switch LEXUS Parking Assist-sensor System Shift Lever Position Vehicle Speed
        On (IG) On In any position other than P

        • Less than approximately 15 km/h (9.3 mph) if speed is increasing

        • Less than approximately 10 km/h (6.2 mph) if speed is decreasing
        On (IG) On R -
        A01FDSVE01

        Tech Tips

        Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.

      2. Front center sensor display and buzzer operation check


        1. When the No. 1 ultrasonic sensors (front center sensor) have detected an obstacle, check the display and check that the buzzer sounds.

        3. Operation Condition
        Engine Switch LEXUS Parking Assist-sensor System Shift Lever Position Vehicle Speed
        On (IG) On In any position other than P or R

        • Less than approximately 15 km/h (9.3 mph) if speed is increasing

        • Less than approximately 10 km/h (6.2 mph) if speed is decreasing
        A01FE1CE01

        • *6: Full screen display

        Tech Tips

        Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.

      3. Rear corner sensor display and buzzer operation check


        1. When the No. 1 ultrasonic sensors (rear corner sensor) have detected an obstacle, check the display and check that the buzzer sounds.

        4. Operation Condition
        Engine Switch LEXUS Parking Assist-sensor System Shift Lever Position Vehicle Speed
        On (IG) On R -
      A01FEGPE01

      • *5: Full screen display

      Tech Tips

      Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.

    5. Rear center sensor display and buzzer operation check


      1. When the No. 1 ultrasonic sensors (rear center sensor) have detected an obstacle, check the display and check that the buzzer sounds.

      6. Operation Condition
      Engine Switch LEXUS Parking Assist-sensor System Shift Lever Position Vehicle Speed
      On (IG) On R -
    A01FJ0RE01

    • *6: Full screen display

    Tech Tips

    Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.