G-BOOK SYSTEM (w/ Telematics Transceiver) Emergency Call Switch Indicator Circuit

WIRING DIAGRAM

A01FHN8E08

INSPECTION PROCEDURE

Tech Tips

When replacing the telematics transceiver, perform the vehicle contract setting Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAP LIGHT ASSEMBLY)


    1. Disconnect the N86 telematics transceiver connector.

    2. Disconnect the Y11 map light assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      N86-17 (IND1) - Y11-6 (IND1) Always Below 1 Ω
      N86-16 (IND2) - Y11-18 (IND2) Always Below 1 Ω
      N86-19 (SIG-) - Y11-21 (GND3) Always Below 1 Ω
      N86-17 (IND1) - Body ground Always 10 kΩ or higher
      N86-16 (IND2) - Body ground Always 10 kΩ or higher
      N86-19 (SIG-) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT MAP LIGHT ASSEMBLY


    1. A01FFBVE07

      Remove the map light assembly Click here.

    2. Connect 2 1.5 V dry-cell batteries in series.

    3. Connect a positive (+) lead to terminal Y11-6 (IND1) or Y11-18 (IND2), and a negative (-) lead to terminal Y11-21 (GND3) of the map light assembly connector.

    4. Check if the illumination for the emergency call switch comes on.

      OK
      The red indicator comes on when the positive (+) lead from the batteries is connected to terminal Y11-6 (IND1) and the negative (-) lead is connected to terminal Y11-21 (GND3).
      The green indicator comes on when the positive (+) lead from the batteries is connected to terminal Y11-18 (IND2) and the negative (-) lead is connected to terminal Y11-21 (GND3).

    NG

    REPLACE MAP LIGHT ASSEMBLY Click here

    OK

    REPLACE TELEMATICS TRANSCEIVER Click here