NAVIGATION SYSTEM, Diagnostic DTC:B15F7

DTC Code DTC Name
B15F7 Certification ECU Vehicle Information Reading/Writing Process Malfunction

DESCRIPTION

This DTC is stored when items controlled by the certification ECU cannot be customized via the navigation system vehicle customization screen.

Tech Tips

The certification ECU controls the entry and start system (for Entry Function) related items that are customizable via the accessory meter assembly (for 12.3 Inch) or multi-display (for 8 Inch) screen.

DTC Code DTC Detection Condition Trouble Area
B15F7 Certification ECU vehicle setting processing error.

  • CAN communication system

  • Entry and start system (for Entry Function)

  • Certification ECU

  • Multi-media module receiver assembly

INSPECTION PROCEDURE

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System Click here.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Use the GTS to check if the CAN communication system is functioning normally.


      OK
      CAN communication DTCs are not output.
      Result
      Result Proceed to
      OK A
      NG (for LHD) B
      NG (for RHD) C

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    C

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  2. CHECK ENTRY AND START SYSTEM (for Entry Function)


    1. Check if the entry and start system (for Entry Function) is malfunctioning Click here.

      Tech Tips

      Customization may not be possible depending on the malfunction in the entry and start system (for Entry Function).

      OK
      No malfunctions are present in the entry and start system (for Entry Function).

    NG

    GO TO ENTRY AND START SYSTEM (for Entry Function) Click here

    OK

  3. CHECK CUSTOMIZE ITEMS


    1. Display the "Vehicle Customization" screen.

    2. Make a note of the customizable items for each certification ECU related system.

      Tech Tips

      These items shown as customizable via the navigation system vehicle customization screen can also be changed manually. In a following step, a manual procedure will be used.


      1. Check the customize parameters list for the entry and start system (for Entry Function) related items that can be customized via the accessory meter assembly (for 12.3 Inch) or multi-display (for 8 Inch) screen Click here.

    3. Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the accessory meter assembly (for 12.3 Inch) or multi-display (for 8 Inch) screen.

      OK
      The items available for customization via the accessory meter assembly (for 12.3 Inch) or multi-display (for 8 Inch) screen can be customized successfully using the manual procedure.

    NG

    REPLACE CERTIFICATION ECU

    OK

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here