STEERING COLUMN ASSEMBLY INSPECTION


  1. INSPECT STEERING COLUMN ASSEMBLY


    1. A01FF87E10
      Text in Illustration
      *a

      Component without harness connected

      (Tilt Motor)

      Inspect the tilt motor.


      1. Disconnect the tilt motor connector.

      2. Apply 12 V battery voltage to the tilt motor connector. Then check the steering wheel tilt operation.

        OK
        Measurement Condition Specified Condition

        • 12 V battery positive (+) lead → Terminal 1 (TIM+)

        • 12 V battery negative (-) lead → Terminal 2 (TIM-)

        		 The steering wheel tilts up.

        • 12 V battery negative (-) lead → Terminal 1 (TIM+)

        • 12 V battery positive (+) lead → Terminal 2 (TIM-)

        		 The steering wheel tilts down.

        If the result is not as specified, replace the steering column assembly.

    2. A01FF87E09
      Text in Illustration
      *a

      Component without harness connected

      (Telescopic Motor)

      Inspect the telescopic motor.


      1. Disconnect the telescopic motor connector.

      2. Apply 12 V battery voltage to the telescopic motor connector. Then check the steering column telescopic operation.

        OK
        Measurement Condition Specified Condition

        • 12 V battery positive (+) lead → Terminal 2 (TEM+)

        • 12 V battery negative (-) lead → Terminal 1 (TEM-)

        		 The steering column contracts.

        • 12 V battery positive (+) lead → Terminal 1 (TEM-)

        • 12 V battery negative (-) lead → Terminal 2 (TEM+)

        		 The steering column extends.

        If the result is not as specified, replace the steering column assembly.