DESCRIPTION
| DTC Code | Detection Condition | Trouble Area |
|---|---|---|
| C13A7/43 | Both of following conditions are met:
|
|
WIRING DIAGRAM
INSPECTION PROCEDURE
Note
If the parking brake with bracket actuator assembly is replaced, perform the "Reset Memory" and "Acquire Tension Sensor Zero Point" procedures Click here.
Before disconnecting connectors or fuses, turn the engine switch off and wait 20 seconds or more.
This DTC may be output if a manual release cable is used. There is no malfunction. Perform the "Reset Memory" and "Acquire Tension Sensor Zero Point" procedures Click here.
PROCEDURE
CHECK DTC
Check for DTC Click here. Check if DTCs other than C13A7/43 are output.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
| B |
|
GO TO DIAGNOSTIC TROUBLE CODE CHART Click here |
| A |
|
CHECK PARKING BRAKE CABLE
Check if the parking brake cable is securely installed Click here.
| NG |
|
INSTALL PARKING BRAKE CABLE Click here |
| OK |
|
CHECK PARKING BRAKE ASSEMBLY
Check if each part is installed properly Click here.
| NG |
|
PROPERLY INSTALL EACH PART Click here |
| OK |
|
CHECK HARNESS AND CONNECTOR (PARKING BRAKE ECU - PARKING BRAKE WITH BRACKET ACTUATOR)
Disconnect the U37 parking brake ECU assembly connector.
Disconnect the U40 parking brake with bracket actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
REPLACE PARKING BRAKE WITH BRACKET ACTUATOR ASSEMBLY Click here