ELECTRIC PARKING BRAKE SYSTEM DTC CHECK / CLEAR


  1. CHECK DTC AND FREEZE FRAME DATA (with GTS)


    1. Turn the engine switch off, and connect the GTS to the DLC3.

    2. Turn the engine switch on (IG) and the GTS on.

    3. Enter the following menus: Chassis / Electric Parking Brake / Trouble Codes.

    4. Check for DTC.

    5. Check the freeze frame data.

      Tech Tips

      For the freeze frame data confirmation method, refer to the following procedures Click here.

  2. CLEAR DTC AND FREEZE FRAME DATA (with GTS)


    1. Turn the engine switch off and connect the GTS to the DLC3.

    2. Turn the engine switch on (IG) and the GTS on.

    3. Enter the following menus: Chassis / Electric Parking Brake / Trouble Codes.

    4. Clear DTCs.

      Tech Tips

      If you clear DTCs, the freeze frame data will also be cleared.

  3. CHECK DTC (without GTS)


    1. Turn the engine switch off.

    2. A01FDZLE12

      Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040

      Note

      Do not connect the wrong terminals, as this will cause parts to be damaged.

    3. Turn the engine switch on (IG), and read the DTCs from the number of blinks of the parking brake indicator light (red).

      Tech Tips


      • If normal, the light blinks at 0.25 second intervals.

      • If DTCs are stored, refer to the Diagnostic Trouble Code Chart Click here.

      • If there is only 1 DTC, the DTC is displayed with a 4.5 second pause in between displays. If there are several DTCs, the DTCs are displayed with a 2.5 second pause in between each code. Once all of the DTCs are displayed, there is a 4.5 second pause and the DTCs are output again.

      • If 2 or more DTCs are stored, the MIL will display the smaller number DTC first.

  4. CLEAR DTC (without GTS)


    1. Turn the engine switch off.

    2. A01FDZLE12

      Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040

      Note

      Do not connect the wrong terminals, as this will cause parts to be damaged.

    3. Within 5 seconds after turning the engine switch on (IG), push the electric parking brake switch to the lock side 5 times.

      Note

      If the parking brake switch is pushed too fast, it may not respond. If it does not respond, perform the operation again and push the switch more slowly.

    4. Check that a normal system code is output.

      Tech Tips

      If the malfunction continues, the DTC may not be clearable.