REAR SPEED SENSOR INSTALLATION

Tech Tips


  • Other than areas where instructions are provided, use the same procedures for the RH and LH sides.

  • The procedures listed below are for LH side.


  1. INSTALL REAR SPEED SENSOR LH


    1. Install the rear speed sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Prevent foreign matter from attaching to the sensor tip.

    2. Install the 2 harness clamps with the 2 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      When attaching the clamps, do not twist the wire harness.

    3. Install the 2 harness clamps with the 2 nuts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note

      When attaching the clamps, do not twist the wire harness.

    4. Insert the connector and grommet into the inside of the vehicle through the hole in the wheel house.

      A01FH19E01
      Text in Illustration
      *A for RH Side *B for LH Side
      *1 Connector *2 Grommet
      *3 Band Clamp - -
      *a Inside of Vehicle *b Outside of Vehicle
      *c 30° - -

      Note

      Make sure the band clamp remains on the outside of the vehicle.

    5. Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.

      Note


      • When pulling out the grommet, do not grip the sensor wire.

      • Fix the grommet in place within the range shown in the illustration.

    6. Connect the connector on the inside of the vehicle.

      Note

      When attaching the connector, do not twist the wire harness.

  2. INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER LH

    Click here

  3. INSTALL REAR WHEEL HOUSE LINER LH


    1. Install the rear wheel house liner LH with the 9 nuts, 4 clips and 3 screws.

  4. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  5. INSPECT SPEED SENSOR SIGNAL

    Click here