FRONT SPEED SENSOR (for AWD) INSTALLATION

Tech Tips


  • Other than areas where instructions are provided, use the same procedures for the RH and LH sides.

  • The procedures listed below are for LH side.


  1. INSTALL FRONT SPEED SENSOR LH


    1. Connect the connector.

      Note

      Securely connect the connector.

    2. Install the 2 harness clamps with the 2 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note


      • Make sure the clamp rotation stopper touches the installation position.

      • When installing the clamps, do not twist the wire harness.

    3. Install the front fender liner.

    4. A01FHR3E01

      Install the front speed sensor and 2 harness clamps with the 3 bolts.

      Torque:
      for Bolt A
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
      for Bolt B
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note


      • Keep the sensor tip and sensor installation hole free from foreign matter.

      • Firmly insert the sensor body into the knuckle before tightening the bolt.

      • After installing the sensor to the knuckle, make sure that there is no clearance between the sensor stay and knuckle. Also, make sure that no foreign matter is stuck between the parts.

  2. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  3. INSPECT SPEED SENSOR SIGNAL

    Click here