VEHICLE STABILITY CONTROL SYSTEM Slip Indicator Light does not Come ON

DESCRIPTION

Refer to Slip Indicator Light Remains ON Click here.

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON Click here.

INSPECTION PROCEDURE

Note

When replacing the brake actuator assembly, perform zero point calibration and store system information Click here.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if a CAN communication system DTC is output (for LHD: Click here, for RHD: Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output (for LHD) B
      DTC is output (for RHD) C

    B

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    C

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    A

  2. PERFORM ACTIVE TEST USING GTS (SLIP INDICATOR LIGHT)


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Start the engine.

    4. Turn the GTS on.

    5. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

    6. When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List.

      Result
      Result Proceed to
      Data List Display Data List Display when Performing Active Test ON/OFF Operation
      ON Does not change between ON and OFF A
      Changes between ON and OFF B
      OFF Does not change between ON and OFF A
      Changes between ON and OFF B

    B

    GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    A

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here